ok well its just there is more to be gained if you play with your boost tunnel but to do that you also need to do the cases
the tunnel for the boost port you need to widen it at the bottom and then taper it all the way up until it is the same size as the port window
The cases have been opened up across the top. Much much wider do you normally take the boost tunnel?? The casting is not as nice to grind as the sleeves...
I fill the open area of the case with defcon and then take it right out till it almost breaks through and then blend it up from there No deeper just wider
Not the best quality photo, but read something about the Factory B pipes and decided to open it up a bit too..
Still haven't got a new pole so I couldn't tell you. Very responsive on the trailer if that counts...Hasn't had a tune yet either. Still tossing up putting a 61X flywheel on it, I would be keen but just finished putting the eletrical box back together, might do next time I check the flywheel/stator/bendix.
from memory there is stuff all difference in weight between the 61x flywheel and the 62t...i did have it written down somwhere......i normally machine off about 200 grams with the ones ive machined down...basically same dimensions as the ones pro-tec do...