Hi guys, I'm new here and I hope this isn't a stupid question but the hull of my ski has some chips out of it, one is at the rear where the transom meets the bottom.. It doesn't go right through, it looks more like someone has hit a rock or such and just taken a bite out of the edge of the hull about the size of the nail on my little finger. What's the best way to fill these chips?
hey man in the past iv just used a die grinder to grind them out a little,then mixed up some fibre glass resin an added that white fluffy powder they use to thicken it up,then sand an paint!inga
If the chip is the size of your finger nail I'd just ignor it. If its a deeper hole I just seal them with resin to keep the water out
