carb tuning

Just changed the carb on Kawa 750ss single carb, Any1 tell me the factory setting start point for the High n Low speed screws plz (how many turns )... Cheers

on the same topic, but im after the same thing for the twin carbs (750sxi)

Not sure about the single carb but here are the specs for the SXI and SXI PRO

SXI with Keihin, CDK-II 40 X 2

Spark Plug NGK BR8ES
—Gap 0.7-0.8 mm
Ignition Timing 13° BTDC at 12,500 rpm
16 mm at 2,500 rpm
Carburetor
Idle Speed 1,250 ± 100 rpm (in water)
Low Speed Needle 7/8 turn open
High Speed Needle 7/8 turn open
Compression Pressure 12.5 kg/cm2 @ 750 rpm (open throttle)

SXI PRO with Mikuni 40mm Diaphragm Type X 2

Spark Plug NGK BR8ES
—Gap 0.7-0.8 mm
Ignition Timing — Idle Speed 13° BTDC at 1,250 rpm
— High Speed 20.2° BTDC at 4,000 rpm
Carburetor
Idle Speed 1,250 ± 100 rpm (in water)
Low Speed Needle 7/8 turn open
High Speed Needle 7/8 turn open
Compression Pressure 12.5 kg/cm2 @ 750 rpm (open throttle)

thanks azza

cheers azza, did the trick, bit of fine tuning on the low speed , bout 1 n a bit turns...