Separate names with a comma.
Bump
yeap sure do, make an offer
bump
Price reduced and free postage within NZ
[IMG] [IMG] Get yours today for $80 NZD
yes still got pole bracket and worx intake grate
Introducing the Ultimate pisser / Flush kit by MB Fabrications - Corrosion resistant 316 stainless steel construction. - Less noisy when flushing,...
[IMG] Stock 96 SJ hood and nose piece Has a patch cut out of liner to clear dry pipe. $200 62t cases SOLD
Stock 62t Flywheel $85 [IMG] KP Engine keepers (No fasteners) $45 [IMG]
Hey mate is this what you are after? [img] These bow pins are high quality 316 S/S, 16mm diameter and high polished. A nice 'Bling' upgrade...
Bored to 85mm
Yea i got the stock polystyrene in the nose, its the hood that's the problem. don't think those hoods are made for the surf lol. So going to fill...
The ski is now 98% finished just a few little bits to finish off. Primer on hull [img] mocking up lengths for the hood-strap ratchet system...
I'm after a stock plastic steering nozzle for use with trim
Ok long time since an update, should really have it all finished by now. Progress has been slow but been trying to do it all nicely. Aim now is to...
Thanks, Nar the exhaust runs basically the same position as stock thats the position it was easiest to weld it. Yeap two rear footholds, I may to...
Cheers, you are correct hes not the best at emailing back but eventually about 3 and a half months later after i thought i was screwed, a big box...
Ok so finished all my study now, And it’s pretty much summer and want to ride. Update on what I’ve got done so far: Cut tray open wasn’t quite...
Well I thought I might as well start a build thread of my first ski, 96 Yamaha superjet. Before: [img] [img] Mods before: Hull: Blowsion...